Set Review ➟ LEGO® 76921 - Audi S1 e-tron quattro
Here we go with another car from the Speed Champions line. This time we will build an Audi S1 e-tron quattro. It is a set with 274 pieces, one driver, a price of 26,99€ and with a recommended age of 9+.
As always, we see the contents, which on this occasion consists of two bags, a manual, a car base plate and a huge sheet of stickers... Wait a minute, we're starting to see the change from plastic to paper in the container bags! Good!
As usual here is our pilot and some new references for his impression as the mould is not.
The back of the back where the printed plates and the surfboard are placed is just amazing. I'm always fascinated by the way designers use the pieces.
The first bag finishes by building the rear wing and the rear aerodynamic part of the car's cockpit.
I have to say that I am not at all convinced by the seats because the lumbar part is not aligned with the backrest. I don't think the pilot should be very comfortable like that.
Well, second bag and we find that there are quite a lot of new references printed.
In this final part, the front and bonnet of the vehicle, the doors and the roof of the passenger compartment are formed. Once again we find millimetric techniques that are almost impossible to imagine and that show the designers' vast knowledge of the environment.
A car that is tremendously faithful to the original as you can see.
If I had to point out something less positive it would be the windshield wiper as it barely reaches half of the front window, but otherwise it is a well done and very attractive car. Definitely a new addition for collectors of the Speed Champions line, AFOLS in general or even model car lovers! We thank LEGO for sending the set for this article. LEGO in no way endorses the opinions expressed in this review.
33614
